Skip to content

What is jitter and why does it make your calls break up?

Updated: · 4 min read · Daniel Chivico

Some connections have good speed and reasonable average latency, yet calls still sound choppy or robotic. In many of those cases, the culprit is jitter.

What jitter is

Jitter is the variation in latency from one piece of data to the next. If latency is how long each packet takes to arrive, jitter measures how irregular that time is.

Look at these two sets of latencies measured one after another:

Both have a similar average, but connection A is very steady and B is chaos. On A, jitter is 1 to 3 ms. On B, each measurement differs from the previous one by about 70 ms. For a call, connection B is much worse, even though its average "looks fine".

Why jitter ruins voice and video

On a call, your voice is chopped into small pieces that travel one after another. On the other end, the app has to put them back together at the right pace so it sounds natural.

If the pieces arrive at irregular times, the app has two options:

  1. Wait a little, holding them in a small store called a jitter buffer so it can play them back at an even pace. This adds delay to the conversation.
  2. Drop the ones that arrive late, which causes gaps, missing syllables or that familiar metallic voice.

Calling apps combine both and adapt, but when jitter is high no buffer is big enough. Video suffers in a similar way: freezes, pixelated images or audio drifting out of sync with the picture.

What causes jitter

Which jitter values are acceptable?

As a rough guide for calls and video calls:

Jitter Typical effect
Up to 30 ms Good. Calls sound fine.
31 to 50 ms Small gaps or delay may be noticeable.
Over 50 ms Choppy calls and unstable video.

SuperPing uses exactly those ranges to color jitter green, orange or red, and marks your connection as unstable when overall jitter goes above 50 ms.

How SuperPing measures jitter

SuperPing calculates jitter as the average difference between each latency measurement and the next, using the last 20 measurements. It is a simple, easy-to-read approach. Professional VoIP tools use smoothed formulas and measure real voice packets, so the numbers may not match exactly, but the trend is the same: if SuperPing's jitter rises, your calls will notice.

You can see it in three places:

How to reduce jitter

  1. Use a cable if you have an important meeting. It is the single biggest improvement you can make.
  2. Pause downloads and cloud backups during calls.
  3. Move closer to the router or use the 5 GHz band if you rely on Wi-Fi.
  4. Change the Wi-Fi channel if you are surrounded by many networks. Your router's or provider's app usually shows which one is least crowded.
  5. Turn on traffic management (QoS or SQM) if your router has it. It helps keep call traffic from getting stuck behind downloads.
  6. Measure at different times. If jitter only rises in the evening even when nobody else is using your network, the problem is probably congestion at your provider. Keep SuperPing's log as evidence.

In short

Jitter measures how consistent your connection is. You can have good speed and good average latency, but if jitter is high, calls and video calls will suffer. Check it in SuperPing before an important meeting: if it is green, you can join with peace of mind.

Keep reading