Packet loss: what it is, what causes it and how to detect it
Everything you do online travels split into small blocks of data called packets. Packet loss happens when some of those blocks never reach their destination. It is one of the most annoying problems because it tends to come and go and is hard to see with the naked eye.
How packet loss shows up
The effect depends on what you are doing:
- Browsing and downloads. You barely notice. These apps use mechanisms that detect the missing packet and ask for it again. The result is that things just get a bit slower.
- Calls and video calls. There is no time to request a piece of voice that should already be playing. The lost packet turns into a gap, a missing word or a frozen image.
- Online games. You get the famous "jumps": characters teleporting, shots that do not register or disconnections from the server.
What causes packet loss
- Weak Wi-Fi or interference. The most common cause at home. With a poor signal, many packets get corrupted in the air and are discarded.
- Damaged or loose cables. A bent, crushed network cable or a loose connector can lose data intermittently.
- An overloaded or faulty router. Old or overheating routers can drop packets when they are busy.
- Congestion. When a link is full, network equipment drops packets to ease the load.
- Provider problems. Faults in the outside network, damaged fiber splices or failing equipment.
- The destination server. Sometimes the problem is not your connection but the service you are connecting to.
How much loss is acceptable?
Ideally 0%. As a rough guide:
| Loss | Typical effect |
|---|---|
| 0% | Healthy connection. |
| Under 1% | May go unnoticed while browsing, but shows up on demanding calls. |
| 1% to 5% | Frequent gaps in voice and video, jumps in games. |
| Over 5% | Calls are hard to keep going and games become nearly unplayable. |
SuperPing colors loss green at 0%, orange below 5% and red from 5% upward.
How SuperPing measures it
SuperPing counts how many of its checks got no response within the 4-second time limit. It is a practical way to detect loss from a browser, with one difference from network tools: each SuperPing check is a full web request, not a single packet. That is why it picks up outages and heavy loss better than very small, isolated losses.
The useful part is combining two views:
- Per target. If only one server shows loss and the others do not, the problem is that server or the route to it.
- Overall. If loss appears on every target at once, the problem is your network or your provider.
Step-by-step diagnosis
- Leave SuperPing open for a few minutes and see whether loss appears on all targets or just one.
- Connect with a cable if you can. If loss disappears over cable, the Wi-Fi is to blame.
- Try a different cable and router port if you were already wired.
- Restart the router and make sure it is not hot or shut inside a cabinet with no airflow.
- Temporarily disconnect other devices to rule out saturation.
- Measure at different times. If loss always shows up at peak hours, it points to congestion at your provider.
- Document it and complain if loss persists over cable with no other devices: the problem is probably outside your home. We explain how in documenting outages to complain.
How to reduce packet loss
- Improve your Wi-Fi signal: move the router, avoid obstacles and use 5 GHz when you are close.
- Replace old or damaged cables.
- Update the router's firmware, or replace it if it is very old.
- Avoid chaining cheap Wi-Fi repeaters; a mesh system or a wired access point usually works better.
- If none of the above works, ask your provider for a technical check of the line.
In short
Packet loss barely affects downloads, but it is devastating for calls and games. Check in SuperPing whether it appears on every target or just one, test over cable to rule out the Wi-Fi and, if it persists, document the results to show your provider.